Difference between revisions of "K2CC Repeater"

From K2CC Wiki
(Repeater Administration)
(23 Centimeter 1284.00- (Voice) 1298.00 (Data))
Line 13: Line 13:
 
===70 Centimeter DMR: 443.3500+ Mhz===
 
===70 Centimeter DMR: 443.3500+ Mhz===
 
The 70 centimeter DMR repeater is currently off air.
 
The 70 centimeter DMR repeater is currently off air.
 
===23 Centimeter 1284.00- (Voice) 1298.00 (Data)===
 
The 23 centimeter (1.2GHz) repeaters are used for D-STAR data and voice.  The voice repeater has with a -12 MHz offset and the data repeater is simplex.
 
 
The voice repeater is connected to [http://ref001.dstargateway.org/ REF001C] by default.  For more information on using the D-STAR gateway for voice or data, see [[Using D-STAR]].
 
  
 
==Location==
 
==Location==

Revision as of 13:36, 20 April 2018

The K2CC 2m Repeater is: On Air

The K2CC D-Star Repeater is: On Air

The K2CC DMR Repeater is: Off Air

Public Repeater Operation

2 Meter: 146.895 MHz

The K2CC 2 meter (VHF) repeater has an output frequency of 146.895 MHz, with a -0.6 MHz offset. It requires a CTCSS tone of 151.4 Hz. The 2 meter repeater supports IRLP and is node 4747.

This repeater is linked to the East Coast Reflector by default. It can be disconnected from this reflector by dialing 73. The repeater will reconnect after 3 hours.

70 Centimeter DMR: 443.3500+ Mhz

The 70 centimeter DMR repeater is currently off air.

Location

The K2CC Repeaters are located on the Science Center Tower at Clarkson University. Its location is shown on the map below.

Loading map...

Repeater Administration

Control Commands

IRLP is supported on the 2m repeater. To connect to another node, dial its number on a DTMF keypad. To disconnect dial "73". The K2CC repeater's node number is 4747.

2m Equipment

Controller

Link Communications RLC-2. The programming manual can be found here.

2m Port

The repeater is a Vertex Standard VXR-9000, bought in spring 2013 through alumni donations.

The 2m transmitter/receiver was previously a modified GE Mastr II.

IRLP Controller

The IRLP controller is a Dell R710 server with an IRLP v3 interface board, sound card and parallel card.

D-Star Equipment

All of the D-Star repeaters share a single Icom ID-RP2C controller.

23 cm Repeater

The 23 cm repeater uses an Icom ID-RP2V voice repeater module connected to port 4 of the controller and an Icom ID-RP2D data module connected to port 1.